Alcon Antrasil Automatic Dose RTV Black Gasket Maker
- Neutral oxym based rising generation gasket maker.
- After curing, it doesn’t give off odour that affects the sensors bad.
- Resists shrinking and cracking caused by exposure of thermal cycling.
- After curing, it works between -40 °C and +300 °C.
- Improved resistance particularly greased and dirty surfaces.
- After curing, it resists to oil, antifreeze, petrol, diesel and sea water.
- Can be demounted.
- Strong adherence, hiding power, constant elasticity, ekstra sealing.
- Pure silicone, does not contain any organic extender.
| Product Code | Color | Packaging Type | Pieces |
| M-3321 |  Black | 200 ml. Aluminium Cartridge | 12 |
| M-3322 |  Red | 200 ml. Aluminium Cartridge | 12 |
| M-3323 |  Grey | 200 ml. Aluminium Cartridge | 12 |
Colors : Red-Black-Grey
Curing : Single Component Oxime
Elongation At Breaking :22
Density : 1,05 gr / cm3
Elastic Recovery : 450 %
Tack-Free Time : 10 minutes
Moving Capability : 15 %
Drying : 3 mm / day
Service Temperature :-60° C to +300° C
Extrusion Rate : 220 gr / minute
Application Surface Temperature : +5° C to +40° C
Application Surface Preparation
Surfaces to contact with silicone must be clean and dry and not contain oil, dust, rust and loose parts.
If there is previously applied silicone on surfaces, it will be removed by mechanical methods.
Applying masking tape around the application joints does not only prevents smudging of joints but provides a more aligned application as well.
Masking tape must be removed promptly after application.
Application Method
Apply the gasket on a surface, wait for 5-10 minutes, then assemble the pieces.
If the surfaces are small, the pieces can be assembled right away.
The lid of the package is opened before the application. The safety tab is severed. The dosage setting required for the application is set on the gray ring. By pressing the plastic pedal, the liquid gasket is released. When the pedal is released, the fluid seal stops. To keep the product healthy until the next use, the dosage setting and the packaging cover are closed again.
Application Surface Preparation
Surfaces to contact with silicone must be clean and dry and not contain oil, dust, rust and loose parts.
If there is previously applied silicone on surfaces, it will be removed by mechanical methods.
Applying masking tape around the application joints does not only prevents smudging of joints but provides a more aligned application as well.
Masking tape must be removed promptly after application.
Application Method
Apply the gasket on a surface, wait for 5-10 minutes, then assemble the pieces.
If the surfaces are small, the pieces can be assembled right away.
The lid of the package is opened before the application. The safety tab is severed. The dosage setting required for the application is set on the gray ring. By pressing the plastic pedal, the liquid gasket is released. When the pedal is released, the fluid seal stops. To keep the product healthy until the next use, the dosage setting and the packaging cover are closed again.
Do not throw full / empty packaging into fire. Keep away from sunlight and store at temperatures not exceeding +50 ° C.
Keep out of the reach of children.
Keep container in a well-ventilated place.
Keep away from sources of ignition, no smoking.
Avoid contact with eyes and skin.
In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
Wear suitable protective clothing, gloves and eye / face protection.
In case of accident or if you feel unwell, seek medical advice immediately (show the label where possible).
If swallowed, seek medical advice immediately and show this container or label.
Do not pour into sewer system. Dispose the waste and its container according to local hazardous or special waste collection rules.
